PMMA Model & TryIn
DEGOS Model & TryIn is a high-quality modeling plastic which is specially designed for fast and precise machining. The material does not smear and can be milled well even without water cooling.
Further information
- Density: approx. 1.60 g/cm3
- Flexural strength: approx. 80 MPa
- Shore hardness: 85-90
- Colour: ivory
- Dimensional stability: 75°C - 80°C
- Upper and lower jaw models
- Model segments
- If necessary for the short try-on
- High density, very good dimensional stability
- Very good and high-speed milling, does not lubricate
, can also be machined without water cooling
- Very good value for money
- Low cutter wear